Table of Contents
Advertisement
Rack Rail Parts
Outer Rail
This side
faces out
The
rail assembly
consists of three parts:
•
Outer
rail: connects to the rack
•
Middle
rail: connects the inner and outer rails
•
Inner
rail: connects to the device.
The
inner rail
has a
locking tab
that locks the device into place when it is installed and
pushed into the rack. This
prevents
the device from
device is being worked on.
There are
four steps
to install the device into the rack:
1.
Disassemble
the rail assembly
2. Attach the
inner rails
to the device
3. Install the
outer rails
on a rack
4. Install the device into
the rack
10
Rail Assembly
Middle Rail
Inner Rail
Locking
Tab
sliding
fully out of the rack when the
Disassemble the rail assembly:
2
1
3
1.
Identify
the left and right rail assemblies.
2.
Pull out
the inner rail until it is fully extended.
3. Press down the
locking tab
to release the inner rail.
4. Remove the
inner rail
from the outer rail.
5. Repeat steps 2 - 4 for the remaining rail assembly.
Caution:
Do not pick up the server by the
pull the unit from the rack.
Attach the inner rails to the device:
1. Ensure that the
right and left rails
are correctly identified.
2. Place the
inner rail
against the side of the device, enduring that the
of the device align with the
holes
in the rail.
3. Slide the rail towards the front of the device until the rail
position.
4. Optionally,
secure
the rail to the
device
5. Repeat steps 2 - 4 for the remaining rail.
4
front
handles. They are designed to only
hooks
on the side
clicks
into the
locked
using the provided
M4 Flat Head
screws.
11
Advertisement
Table of Contents
