Table of Contents
Advertisement
Install the outer rails on a rack:
1
2
1. Press up on the
locking tab
on the back of the
2. Push the
middle rail
back into the outer rail.
3
3. Hang the
hooks
on the front of the outer rail to the
provided
washers
and
M5 12L Flat Head screws
4.
Pull out
the back of the outer rail to adjust its
5. Hang the
hooks
on the back of the rail to the
of the provided
washers
and
M5 12L Flat Head
6. Repeat steps 1 - 5 for the remaining rail.
12
middle
rail.
slots
on the rack. Use two of the
to secure the rail to the rack.
4
length
until it fits properly in the rack.
slots
on the back of the rack. Use two
screws to secure the rail to the rack.
Install the device into the rack:
1. Ensure that the inner rails are
properly connected
outer rails are
securely attached
to the rack.
2. Pull the
middle rail
out from the front of the outer rail until it locks.
3. Align the inner rails with the middle rails and
locking tab
on the inner rails
clicks
into the front of the middle rails.
Ensure that
even pressure
is applied to both sides of the device while doing this.
4. Push down the
locking tabs
on both sides at the same time, then push the device all
the way into the rack.
5. When the unit has been completely pushed into the rack, the
into the locked position.
6. For additional security, secure the chassis handles to the front of the rack with the
provided
M5 20L Truss Head
screws.
to the device, and the that the
slide the device
onto the rails until the
locking tabs
will click
13
Advertisement
Table of Contents
