Table of Contents
Advertisement
Overheating/Dry-Run Protection
The appliance is equipped with the overheating/dry operation protection. In the
case of accidental start-up without water or with its insufficient amount, the
protection will be activated and the appliance will be automatically switched off.
To reset the appliance, perform the following steps:
Fig. 4
5. Fill the water tank with fresh water.
6. Switch the appliance on as usual and check if the heating up indicator light will
be lit.
EN
If the light will be lit, it means that the appliance is operating normally again.
7. If the indicator light is still not lit, pull the plug out and press the RESET key
again.
8. Perform this process a few times more, until the appliance will be operating
normally again.
9. If the appliance does not switch on again after pressing the RESET key several
times, contact the service company for further verification.
NOTE!
The safety device may accidentally switch off during transport; if this
happens, reset the thermal switch according to the instructions above.
18 / 20
1. Disconnect the appliance from mains power
supply.
2. Wait for the appliance to cool down.
3. Following the cooling phase empty the water
tank.
4. Press the RESET key.
The RESET key is located at the bottom side of the
appliance.
Installation and operation
200128
Advertisement
Table of Contents
