Trouble Shooting - Stanley SXPG42602 Owner's Operating Manual

Petrol line trimmer straight shaft 4 stroke 26cc
Table of Contents

Advertisement

Problem
Engine will not start
Engine does not reach full
speed and emits excessive
smoke
Engine starts, runs, and
accelerates but will not idle.
Engine emits too much
smoke.
Line will not advance.
Spool retainer hard to turn.
Grass wraps around
driveshaft housing and string
head.
Possible Cause
No spark
No fuel
Engine is flooded
Air filter is dirty
Spark arrestor screen is dirty
Spark plug fouled
Idle speed screw on carburettor
needs adjustment.
Too much oil in crankcase.
Line welded to itself.
Not enough line on spool
Line is worn too short.
Line is tangled on spool.
Engine speed is too slow
Screw threads are dirty or
damaged
Cutting tall grass at ground level.
Operating trimmer at part throttle
Solution
Check spark. Remove spark plug. Reattach the spark plug
cap and lay spark plug on metal cylinder. Pull the starter rope
and watch for spark at spark plug tip. If there is no spark,
repeat test with a new spark plug.
Push primer bulb until bulb is full of fuel. If bulb does not fill,
primary fuel delivery system is blocked. Contact a servicing
dealer. If primer bulb fills, engine may be flooded, proceed
to next item.
Set the choke lever to the FULL CHOKE position. Squeeze the
trigger and pull the rope repeatedly until the engine starts
and runs.
NOTE: Depending on the severity of the flooding, this may
require numerous pulls of the rope.
Clean air filter. Refer to "Cleaning the Air Filter"
earlier in this manual.
Contact a servicing dealer.
Clean or replace spark plug. Reset spark plug gap. Refer to
"Spark Plug" section earlier in this manual.
Turn idle speed screw clockwise to increase idle speed.
Drain oil and refill with correct amount of 10W30 engine
lubricant. See "Adding/Checking Engine Oil" in the Operation
section of this manual.
Lubricate with silicone spray.
Install a new spool
Pull lines while alternately pressing down on and releasing
spool retainer.
Remove line from spool and rewind.
Advance line at full throttle.
Clean threads and lubricate with grease - if no improvement,
replace the spool retainer.
Cut tall grass from the top down to prevent wrapping.
Operate trimmer at full throttle.
18

Advertisement

Table of Contents
loading

Table of Contents