Table of Contents
Advertisement
INSTALLING THE CUTTING HEAD SHIELD
WARNING.
The line cut-off blade on the cutting
head shield is sharp. Avoid connection with the blade.
Failure to avoid contact can result in serious personal
injury.
1.
Locate the bolt, nut and washer used to fix the cutting head
shield.
2.
Align the screw hole in the mounting bracket with the
screw hole in the cutting head shield, Fig. 4.
3.
Push the bolt through the mounting bracket and into the
cutting head shield and fix in place with the washer and
nut. Ensure it is tightly fitted before use.
CONNECTING THE UPPER AND LOWER
SHAFTS
The attachment connects to the power head by means of a
coupler device.
1.
Ensure the engine is not on. Disconnect the spark plug wire
2.
Turn the knob counterclockwise to loosen the coupler
of the power head shaft and remove the end cap from the
attachment.
3.
Insert while rotating the lower shaft into the coupler until
the button locks into the positioning hole (the fixing hole is
opposite the knob), Fig.5
NOTE: If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked
into place.
4.
Turn the knob clockwise to tighten the coupler.
WARNING!
Be certain the knob is fully tightened
before operating equipment, check it periodically for
tightness during use to avoid serious personal injury.
REMOVING THE UPPER AND LOWER
SHAFTS
1.
Turn the knob counter clockwise to loosen the coupler.
2.
Press and hole the release button.
3.
Pull the attachment straight out of the coupler.
ASSEMBLY
INSTALLING AND ADJUSTING THE FRONT
HANDLE
To avoid injury, adjust the auxiliary handle for optimum control
and balance. Do not overreach when operating line trimmer.
Keep proper balance at all times for better control of the tool in
unexpected situations.
The auxiliary handle can be moved either up and down the shaft
or rotated 360º around the shaft. To find your optimum desired
position unscrew the front handle locking knob, Fig.6. Once you
have the desired position tighten the front handle locking knob.
11
Fig. 4
1.
2.
Fig. 5
Fig. 6
Advertisement
Table of Contents
