Usb Module - Toshiba PORTEGE R300 Maintenance Manual

4.19 USB module

4.19 USB module
Removing the USB module
To remove the USB module, follow the steps below and refer to Figure 4-29.
1. Remove the following screw securing the USB module.
• M2×4BS
2. Peel of the insulator and disconnect the USB cable from the connector USB on the
system board.
3. Remove the USB module from the system board.
M2×4BS S-THIN HEAD
Installing the USB module
To install the USB module, follow the steps below and refer to Figure 4-29 and Figure 4-30.
1. Secure the USB module with the following screw.
• M2×4BS
2. Connect to the USB cable to the connector USB on the system board.
CAUTION: Pass USB cable / LCD cable / MDC cable in the cable guide.
LCD cable
USB cable
PORTÉGÉ R300 Maintenance Manual (960-591)
All manuals and user guides at all-guides.com
S-THIN HEAD
USB module
Figure 4-29 Removing the USB module
S-THIN HEAD
Figure 4-30 Placements of the cable
4 Replacement Procedures
×1
USB cable
Connector USB
Insulator
×1
Cable guide
MDC cable
[CONFIDENTIAL] 4-39