Requirements For Setup - NEC Express5800 Series Installation Manual

Chapter 1 Installing Windows
3.3.2

Requirements for Setup

Prepare the following media and instruction manuals before starting setup.
 Either of the following OS installation media

NEC operating system installation media (hereafter referred to as Backup DVD-ROM)

Microsoft operating system installation media (hereafter referred to as Windows Server 2016
DVD-ROM)
 Starter Pack
 Starter Pack DVD (Optional or downloading from our website)
3.3.3
Installation procedure
1. Turn on peripherals (such as a display), and then turn on the server.
Insert OS installation media into the drive.
2. To run EXPRESSBUILDER, press <F10> key during POST.
On the One-Time Boot Menu, select the optical disk drive in which the OS installation media was
inserted.
3. The system starts from the OS installation media.
The message "Press any key to boot from CD or DVD..." is displayed on the upper of the screen.
Press the <Enter> key to start from the media.
The boot sequence proceeds and the message "Windows is Loading files..." appears.
4. Click Next.
34
Note
If using the onboard RAID controller and the internal optical disk drive, the driver is
loaded from a removable media device.
Copy and prepare the following files onto a removable media in advance.
<DVD>:\software\005\drivers\sw_raid1_driver
Note
Read the precautions in Chapter 1 (3.1 Precautions of Windows Server 2016
Installation) in advance.
Note
If the Windows Setup screen (the screen in the next step) does not display, the
<Enter> key was not properly pressed. Turn the system power on again, and then
start again.
Express5800/R110j-1 Installation Guide (Windows)
Installing Windows Server 2016