Table of Contents
Advertisement
1.
Connect a shielded CAT 5e or better Ethernet cable to the connector of the
converter. For information on the converter connectors, see the appropriate
converter manual. For more information on the cable, see
2.
Connect the other end of the cable to connector X3 of the FDPI-02 unit. For the
X3 pin information, see section
3.
Make sure that termination switch S1 of the FDPI-02 is in the OPEN position.
For connecting the PC to the commercial USB - RS-485 converter or Ethernet - RS-485
converter, see the appropriate converter and PC manuals.
Pin allocation (page
Electrical installation 25
RS-485
bus.
32).
Advertisement
Table of Contents
