Table of Contents
Advertisement
10 Hardware description and operation principal
1
Lock
2
X101 (under the dust seal)
3
Mounting screw
4
Termination switch S1
5
Slide for chassis/grounding screw, and the screw
6
X100
Connector or
Description
switch
X1
RJ-11 female control unit connector
X2
Daisy chain bus terminal 1, RJ-45 shielded female connector for connecting a control
panel.
The connector feeds the panel supply voltage and LED signals. Chaining the panel
to the next drive is done by using terminal 2 (X3). For a chaining example, see
Panel bus termination and chaining examples on page
Note: To avoid damage caused by the panel voltage or LED signals, do not connect
the PC to connector X2. The PC does not support the RS-485 bus.
1
2
3
4
5
6
25.
Advertisement
Table of Contents
