Malfunction
1. PE pipe is cracked.
2. PE pipe is not inserted properly into
the port.
Leakage in
3. The tubing end tip is not cut well.
connections
The filter is not installed correctly.
The feed water adapter is not installed
correctly.
No display on
the control
The system is not connected to power.
panel
The booster pump is overworking.
Automatic
The booster pump turns on and off
shutdown
frequently.
www.123filter.com
Malfunction Inspection
Possible Issue
| (678) 261-7611 |
Possible solution
1. Replace the pipe.
2. Reinsert the pipe about 1/2'' into the
port.
3. Make clean cuts on the tubing.
Correctly assemble the filter.
Correctly assemble the feed water
adapter.
Check the power.
Unplug and plug in the booster pump.
Close the inlet valve and verify there is
no leakage in the system. Unplug and
plug in the booster pump.
support@123filter.com
Page 15