Table of Contents
Advertisement
-
Each time the system is plugged into a power outlet, the system will initiate an automatic
rinse process that lasts 18 seconds. Each time after the system has been idled for over 24
hours, the system will initiate an automatic rinse process that lasts 18 seconds. An 18-
second manual rinse can be initiated by pressing the "Rinse" button for 5 seconds. During
the rinse process, automatic or manual, the "Rinse" light will blink blue.
B. ''Filter Service Life'' Light:
Service Life
Filter Life End
5) Filter Service Life Reset
After replacing the filters, reset the filter status by pressing and holding the corresponding
filter button for 5 seconds. A "beep" will sound as the button is pressed, and the indicator will
turn red – hold the button until the indicator light turns solid blue.
Note: In the event that multiple filters are replaced at the same time, perform the reset
sequence one filter at a time. DO NOT reset multiple filter lights at the same time.
Malfunction Inspection
6)
Fault Codes
Type
Timeout protection
for continuous pump
operation.
Water Dispensing >1
hr.
Water
leakage
protection.
Low incoming water
pressure.
In case of issues/questions/concerns, please contact iSpring Support at support@ispringfilter.com
Page 14
www.123filter.com
Filter Life Indicators
Normal
Solid Blue
<10%
Blink Red
Solid Red
Reminder
"Rinse"
Filter Life
Light
Indicators
Blink
Blink Blue
Blue
Blink Red
Blink Blue
Blink Red
Blink Red
| +1 (678) 261-7611 |
Prompt
Buzzer
None
Beep
Beep
Buzzer
Shut off the faucet, u
from the power outlet, let it rest for 1
Beep
minute, then plug it back in, resuming
normal operation.
Unplug the system from the power
outlet; check and clean/fix the leak, then
Beep
plug the system back in, resuming
normal operation.
Check the inlet water supply status or
incoming water pressures. The system
Beep
will resume functional status when the
water pressure returns to normal.
Support@123Filter.com
Solution
nplug the system
Advertisement
Table of Contents
