Advertisement
Dahua HD Mobile Network Camera Quick Start Guide
Note
Long press the reset button for 10s with power on if it needs to restore the device
factory settings.
Step 3 Fix the device on the installation surface.
1.
Take out the installation position map from the accessory bag, paste it
on the installation surface according to the monitoring area.
2.
Dig 3 plastic expansion bolt bottom holes on the three hole sites with
cross sign on the installation position map, and then insert 3
expansion bolts into the mounting holes and lock them firmly.
3.
Adjust the location of device installation pedestal, lead the cable into
the outlet hole on the installation surface, take out the silica gel from
the accessory bag and place it on the corresponding location of
mounting pedestal, then align the pedestal fixing holes with the three
expansion bolt fixing holes on the installation surface, tighten three
self-tapping screws into the three plastic expansion bolts and lock
them firmly, fix the pedestal on the installation surface.
Note
It needs to remove the side cable outlet slot on the upper cover
component by hand or sharp-nose pliers if the device adopts side
cable outlet.
Step 4 Adjust device monitoring direction
Loosen one screw which is located on the right of the compression cover (don't
demount it completely), adjust the direction of lens monitoring image to proper
monitoring angle, it is recommended to use inner hex wrench to adjust, and
then tighten the screw back in place, which is shown in Figure 2-3.
Figure 2-2
7
Advertisement
