Zirkon zahn titanium spectral-colouring anodizer Operator And Maintenance Manual page 36

KAPITEL 9
INSTRUCTIONS
17
18
19
2o
Press the start button. The light turns blue.
Select the anodising time depending on the size of
the workpiece (Short push – 3 seconds anodising
time)
(Long push – 11 seconds anodising time)
Close the front panel of the Titanium Spectral-
Colouring Anodizer.
When the signal tone sounds, the electronic
process starts.
After the signal tone sounds again and the blue
overhead lighting comes on, the Titanium Spectral-
Colouring Anodizer can be opened again.
The anodised part's surface has adopted the colour.
Now it can be taken off the connection and should
be cleaned thoroughly with water.
A new anodising process can be started
immediately (see step 13).
36 36