Workplace, Handling, References To Safety; Troubleshooting; Sources Of Danger And Risks; Residual Risks - Zirkon zahn titanium spectral-colouring anodizer Operator And Maintenance Manual

CHAPTER 1 13 13
SAFETY / RESIDUAL RISKS

Workplace, handling, references to safety

- Provide optimal work height.
- Provide sufficient room lighting (at least 500 lux).
- Position the equipment in order to access all operating elements without problems.

Troubleshooting

Only instructed qualified personnel are allowed to undertake troubleshooting.
If a malfunction cannot be rectified through the information provided in the Operator's
Manual, the Titanium Spectral-Colouring Anodizer must be turned off. Prevent unauthorised
operation. Please contact your Zirkonzahn partner for troubleshooting.

SOURCES OF DANGER AND RISKS

Residual risks

- Avoid residual risks by increased attentiveness.
- Pay attention to risks at the installation site.
- Risk of bruising when handling the device improperly.
- Stab and cut injuries through tools.
- Risk of bruising during transport and installation of the device.
- Defective power supply lines.

Danger of explosion

It is strictly forbidden to use the device in explosive atmospheres and to clean it with solvents.