Electrical Connection; Installation - STEINEL professional Series Manual

The BT IPD version can be interconnected
with other sensors via Bluetooth to extend
the detection zone. It passes on the de-
tected signals (presence and light level) via
Bluetooth. This is controlled in the sensor
interconnected with other interface.
UP: concealed version
AP: surface-mounted version
Cable length between sensor and button
< 50 m.
Package contents (Fig. 3.1, Fig. 3.4,
Fig. 3.7, Fig. 3.10)
Product dimensions (Fig. 3.2, Fig. 3.5,
Fig. 3.8, Fig. 3.11)
Product components (Fig. 3.3, Fig. 3.6,
Fig. 3.9, Fig. 3.12)
A Surface-mounting adapter
B Load module
C Connecting terminal
D Sensor module
True Presence ® detection zone
(Fig. 3.13)
Hallway detection zone (Fig. 3.14)

4. Electrical connection

The mains supply lead is a multiple-core
cable (max. conductor Ø 2.5 mm):
L = Phase conductor (usually
black or brown)
= Neutral conductor (usually blue)
N
= Protective-earth conductor
PE
(usually green / yellow)
= Switched phase conductor

(usually black, brown or grey)
S = Switch
B0 / B1 = Floating relay for controlling
HVAC
Important: Incorrectly wired connections
will produce a short circuit later on in the
product or fuse box. In this case, you
must identify the individual cables and
re-connect them.
Connect the mains power supply lead
COM1
(Fig. 4.1, Fig. 4.4. Fig. 4.7)
Connect the mains power supply lead
COM2
(Fig. 4.2, Fig. 4.5, Fig. 4.8)
Connecting the BT IPD mains power
supply lead
(Fig. 4.3, Fig. 4.6, Fig. 4.9)

5. Installation

• Check all components for damage.
• Do not use the product if it is damaged.
• Select an appropriate mounting loca-
tion, taking the reach and presence
detection into consideration.
Mounting procedure
• Switch off power supply
(Fig. 4.1, Fig. 4.2, Fig. 4.3)
Concealed mounting
• Connect to mains power supply.
(Fig. 5.1)
• Fit load module and screw into place.
(Fig. 5.2)
• Fit magnetic sensor module. (Fig. 5.3)
• Switch ON power supply.
Surface mounting
• Mark drill holes and drill. (Fig. 5.4)
• Screw load module into place. (Fig. 5.5)
• Connect to mains power supply.
(Fig. 5.6)
• Fit surface-mounting adapter. (Fig. 5.7)
• Fit magnetic sensor module. (Fig. 5.8)
• Switch ON power supply.
• Make settings.
 "6. Function and settings"
- 20 -