Electrical Connection; Installation - STEINEL IR Quattro HD-2 DALI-2 Manual

– Temperature range:
– IP rating:
– Bluetooth frequency:
– Bluetooth transmission power:
– Power consumption via DALI
(12 - 22.5 V DC, no SELV):
– Max. current consumption in
accordance with IEC 62386-101:
– Max. current consumption
at an input voltage of 10 V
in regular operation:*
– Typical current consumption
at an input voltage of 16 V
in regular operation:*
– DALI start-up time:
* These values will not be exceeded in
regular operation and can be used as
the basis for planning.

4. Electrical connection

DA+ = Connection to the DALI BUS
(brown)
DA- = Connection to the DALI BUS
(blue)
Surface-mounted connection (Fig. 4.1)
Concealed connection (Fig. 4.2)

5. Installation

• Check all components for damage.
• Do not use the product if it is damaged.
• Select an appropriate mounting
location, taking the reach and motion
detection into consideration. (Fig. 3.7)
0°C to +40°C
IP20
2.4-2.48 GHz
5 dBm / 3 mW
84 mA / 42 users
32 mA / 16 users
19 mA / 10 users
< 1 s
- 14 -
Mounting procedure
• Switch off power supply (Fig. 4.1/4.2)
Concealed mounting
• Make connection. (Fig. 5.1/4.2)
• Firmly screw load module into mount-
ing box. (Fig. 5.2)
• Fit magnetic sensor module on frame.
(Fig. 5.3)
• Switch ON power supply. (Fig. 5.3)
• Make settings.
➜ "6. Function and settings"
Surface mounting
• Mark drill holes and drill. (Fig. 5.4)
• Feed through cable. Screw load
module into place. (Fig. 5.5)
• Make connection. (Fig. 5.6/4.1)
• Break out the mounting tab. (Fig. 5.7)
• Fit surface-mounting adapter. (Fig. 5.8)
• Fit magnetic sensor module. (Fig. 5.9)
• Switch ON power supply. (Fig. 5.9)
• Make settings.
➜ "6. Function and settings"
6. Function and settings
The sensor is put into operation in
accordance with the applicable DALI 2
standard. All functions and commands
of the DALI standard IEC 62386 Part
101, Part 103, Part 303 and Part 304 are
available.
– All sensor values (motion, light level,
temperature and humidity) can be
requested from the DALI-2 Application
Controller.
– Automatic or time-based cyclical
transmission can also be selected for
motion and light levels.
You will find detailed information in the
interface description on the Internet at:
www.steinel.de