Table of Contents
Advertisement
A
outdoor air temperature
B
Time
HOR+HOS
p. 19
"HOR"
: sets the heating threshold value
p. 19
"HoS"
: sets the hysteresis value in sanitary
p. 18
: hysteresis
"IHY"
Setpoint timeout
When the heat pump fails to reach the setpoint within a given time, three situations can occur depending on the setting of
the connected parameters:
p. 20
"HTO"
: sets the plant water timeout value
Water high-temperature request
The intervention of the auxiliary generator can be enabled when the required water temperature exceeds the maximum value
that can be reached by the heat pump:
The setting can be differentiated for plant water and domestic hot water.
p. 19
"HIS"
: sets the plant water threshold value
The auxiliary backup generators will shut down when the storage temperature is less than the maximum allowed temper-
ature.
5�5 Dynamic set adjustment
The dynamic set function allows the creation of compensation algorithms based on the settable parameters according to the
operating mode.
5�5�1 Function enabling
The dynamic set adjustment must be enabled by parameter "CLI"
A
HOR
C
D
FUnCTIon SETTInG InDooR UnIT WITH InTEGRATED WATER TAnK
INDOOR UNIT WITHOUT INTEGRATED WATER TANK
C
Auxiliary heater
D
Heat pump
p. 20
B
43
Advertisement
Table of Contents
