Dynamic Set Adjustment; Function Enabling; Heating Mode Settings - TESY MultiThermica User's And Installer's Manual

p. 19
"SHY" : Health hysteresis
p. 18
: Setpoint WINTER (Heating)
"ISP"
p. 18
"IHY" : WINTER Hysteresis (Heating)
p. 20
"HTo" : Resistance timeout
p. 19
"HIE" : Auxiliary heater management
Water high-temperature request
If a setpoint above 50 °C is set, the controller switches the heat pump off and the auxiliary heater on. When this function is
active, there will be no simultaneous operation of the heat pump and auxiliary heater.
A
Water temperature
B
Heat pump
HIS-SHY/HIS-IHY HIS
p. 19
"HIS" : Maximum water temperature for pdc function
p. 19
"SHY" : Health hysteresis
p. 18
: WINTER Hysteresis (Heating)
"IHY"
p. 18
"SSP" : Sanitary setpoint
p. 18
"ISP" : Setpoint WINTER (Heating)
4�5 Dynamic set adjustment
The dynamic set function allows the creation of compensation algorithms based on the settable parameters according to the
operating mode.
4�5�1 Function enabling
The dynamic set adjustment must be enabled by parameter "CLI"
4�5�2 Heating mode settings
Settable parameters:
FUnCTIon SETTInG InDooR UnIT WITHoUT InTEGRA TED WA TER T AnK INDOOR UNIT WITHOUT INTEGRATED WATER TANK
C
Auxiliary heater
SSP-SHY/ISP-IHY SSP/ISP
p. 20
C
B
A
33