Table of Contents
Advertisement
Relevant node
information
including
firmware
revision
Graphic of
module
"Diagnostic
word" data
*Note
The G3 node must be switched to Pre-Operational mode via the Twincat system
manager software to allow forcing output states from the G3 webpage. See next
page
G3 Series EtherCAT
TDG3ECM1-5EN
Subject to change without notice
www.asco.com/g3
Technical Manual
TM
07/2020
Valve coil forcing
capability. Can
be disabled with
password
Shows diagnostic
status of whether
coils are shorted
or open.
13-140
Advertisement
Table of Contents
