Breakaway Floor-Tool; Machine In Use - Numatic TTB 6055/100T Owner's Instructions Manual

Breakaway Floor-tool

27
The floor-tool design incorporates a breakaway feature.
Allowing it to safely disengage from its mounting should it become caught on an obstruction, during forward machine
movement. (See Fig.27)
To re-attach the blade to its holder. First loosen the retaining knobs on the floor-tool body and slide onto the holding bracket.
Tighten retaining knobs to finger tight. (See Fig.28)
!
Note: Care must be taken to reduce speed when cornering or when manoeuvring around obstacles
Machine Operation
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.

Machine in use

To operate, turn the main control on / off key to position '1', select water flow rate,
lower the floor-tool (see page 13) press the start / stop trigger.
Vacuum pick-up, water-flow and chemical-dose will turn on automatically and the
machine will move forward.
The clean-water / chemical mix is dispersed evenly via 'THRU- FEED' scrubbing
brushes.
The waste-water is then retrieved by the suction floor-tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on inclines that exceed (9%), when full.
On heavily soiled floors use a
'double scrub' technique.
First pre-scrub the floor with the
floor-tool in the raised position,
allow the chemical time to work
then scrub the area a second time
with the floor-tool lowered.
If streaking occurs wipe floor-tool
blades clean (see Fig.29).
28
34
29
!