Battery Care - Numatic TTB 6055/100T Owner's Instructions Manual

44

Battery Care

To ensure your machine remains at its maximum efficiency and prolong your battery life,
please follow the simple steps below:
Under normal daily usage:
Recharge batteries after each use regardless of machine operation time. (See page 42)
Showing location of Viewing panel for charging-light sequence (Fig.44).
Signal (LED)
Red
First phase (constant current mode)
LED on
Yellow
Second phase (constant voltage mode)
LED on
Green
Third phase (constant voltage mode) charge completed
LED on
Charging System Error
Red
Unsuitable battery or charging malfunction safety timer exceeded
LED
Internal short circuit, disconnect from power supply, switch power supply,
flashing
OFF then ON, to restart the charging cycle
Yellow
LED Battery not connected
flashing
Recharge the machine fully after its last use.
Do not leave the machine in a discharged state.
Under abnormal use; i.e. leaving the machine without charging
for a period of time - we advise that you follow these steps:
If the machine will be standing unused for a period of 30 days
or more, then batteries must be fully charged and battery fuses
removed using the Maxi fuse-puller provided, prior to this period.
Batteries should be recharged every three months.
Charge fully the day before you start using the machine again.
Meaning
44