Fitting The Hose Guide; Filling The Clean-Water Tank - Numatic TTB 6055/100T Owner's Instructions Manual

Fitting the Hose Guide

The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched
off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation.
DO NOT push the vacuum hose onto the Floor-tool with the Floor-tool in the raised position.

Filling the Clean-water Tank

The TTB 6055/100T is equipped with a large capacity clean-water tank allowing, for large areas to be covered in a
single fill.
16
To fill the clean-water tank, extend the hose located to the rear of the machine in the centre of the removable filler cap, see
(Fig.14). Pull out hose, (Fig.15). Open the stopper (Fig.16) and place hose under water tap, or use a hose to commence
filling, (Fig.17). Or the tank can be filled by unscrewing the filler cap and using a bucket or similar container (Fig.18).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
Machine Set-Up
14
17
Note:
15
24
Refit vacuum hose to the
Floor-tool when finished.
18