4. External Controls
4. 1. Control through Serial terminal
SERIAL terminals which are on the side of the projector conform to RS-232C standard. This projector can be controlled
by a PC which is connected as shown below. Also SERIAL OUT terminal is provided to enable plural projector control.
4. 1. 1. Connection
Single projector
●
4. 1. 2. Pin assignments and signal names
4. 1. 3. Communication conditions
4. 1. 4. Communication condition setting
1. Press MENU button of main body or remote controller.
Go to Main menu --> Projector setup. In sub menu,
select "RS-232C" and press ENTER.
2. Select communication condition by pressing ▲ ▼ button.
Set it with pressing button.
3. Press MENU button 3 times and return to regular display.
4. 1. 5. Cable specification
・When connected to a computer
Multiple projectors
●
・When multiple projectors are connected