Removal Of Engine Block Case (Top)/Dmd Block - Panasonic PT-DZ13KU Service Manual

2. 5. Removal of Engine Block Case (Top)/DMD Block
1. Remove the Intake Duct (Assy) according to the section 2.4. "Removal of Intake Duct (Assy) / ACF(Assy)".
2. Unscrew the 3 screws and remove the Engine Block Case (Top).
Engine Block Case (Top)
3. Unscrew the 4 screws and remove the DMD Block.
* Attention when assemble the Engine Case (Top).
Please be careful so that shield rubber of the lens mount department side fits into the installation ditch properly.
RL-P.C.Board
DMD Block
Shield Rubber
Engine Case (Bottom)
DIS-7
* Depending on the position of the focus,
there is the case that is hard to come off.
In that case, please remove the
RL-P.C.board (two screws).
XYN3+F8FJ
XYN3+F12FJK
* Please do straight drawing and inserting of
the flexible cable.
A locking mechanism becomes weak when
make drawing and inserting diagonally.
Installation ditch
Engine Case (Top)