Table of Contents
Advertisement
2. 2. Update by the SERIAL terminal connection
2. 2. 1. Equipment to be used
1. Computer : Use it for the transfer of software.
2. Communication cable : D-sub 9pin (male/female RS-232C straight)
3. Service Software : [MainSubNet Update Tool.exe] Service software is downloaded from the projector service homepage.
4. Microprocessor Software: Please download the file from the projector service homepage to the PC.
2. 2. 2. Connection Preparations
1. Confirm the projector's ID, baudrate, prity and
take a memo.
2. Connect the "SERIAL IN" terminal of projector
and PC with a RS-232C cable.
Attention : Computer, please set so as not to standby or shutdown.
2. 2. 3. Update procedure
1. Switch the projector to "Normal-Standby" mode (POWER indicator is Lighting in red).
2. Start up service software with a computer, select Model, and then click the [OK] button.
3. Select "Serial" in "Connection", and input the ID, Port, Baudrate, Parity , and click [Connection Check] button.
4. A result of the connection confirmation is displayed.
"Check: OK" ⇒ Click a [OK] button and advance next.
"Check: NG" ⇒ Come back to item 3., and please
confirm whether setting is right.
(Main/Sub/Formatter)
ADJ - 12
Advertisement
Chapters
Table of Contents
