Panasonic PT-DZ13KU Service Manual page 72

1. 4. 4. Restore the backup EEPROM Data (After circuit board exchange)
1. Switch the projector to "Normal-Standby" mode (POWER indicator is Lighting in red).
2. Start up service software ［DataLogBackup.exe］ with a computer.
3. Select "Option " ⇒ " Setting" and set Serial Port of the computer, Baud Rate and Parity.
4. Select a model number and ID.
5. 1) Choose "Backup" (an EEPROM).
2) Checkmark in "REPLACE A-PWB" of "COPY MODE".
3) Click an [WRITE EEPROM] button.
6. Select the file and click the [OPEN(O)] button.
7. When the progress bar reaches the right-side end, the write of data is completion.
Select "File" ⇒ "Quit", please exit.
8. When to turn off the main power and turned on again, the setting is complete.
ADJ - 6