Table of Contents
Advertisement
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
1. Remove the
base
cover.
2. Remove the battery.
Procedure
1. Open the latch and disconnect the status-light board cable from the keyboard daughter-board.
2. Peel off the tape that secures the speaker cable to the palm rest and keyboard assembly.
3. Note the speaker-cable routing and remove the speaker cable from the routing guides on the palm rest and keyboard
assembly.
Figure 16. Removing the status-light board
1. latch
3. palm rest and keyboard assembly
5. tape
4. Peel off the foam that secures the status-light board to the palm rest and keyboard assembly.
5. Peel off the status-light board cable from the palm rest and keyboard assembly.
6. Lift the status-light board along with its cable off the palm rest and keyboard assembly.
Removing the status-light board
computer. After working inside your computer, follow the instructions in
2. status-light board cable
4. speaker cable
Removing the status-light board
17
After
www.dell.com/
33
Advertisement
Table of Contents
