Table of Contents
Advertisement
Figure 5.3 Rack thumbscrews
2. Using care to avoid a tipping hazard, extend the enclosure into the
Figure 5.4 Enclosure handles
The enclosure is extended into the serviceable position. Remove the enclosure's
top cover.
REMOVING THE ENCLOSURE'S TOP COVER
To remove the top cover from the enclosure in order to view the FRU component
LEDs, follow these steps:
62
Viking Enterprise Solutions™ Proprietary Information
NOTE: Use a Phillips® #2 screwdriver to loosen the thumbscrews if they are more than
finger tight.
serviceable position by unfolding and grasping the left and right enclosure
handles (see Figure 5.4), and then pulling the enclosure out of the rack
until the rails lock in the serviceable position. This process is
accompanied by an audible click.
ONYX Series Harware Guide
Document CTC-DOC-003005
Advertisement
Table of Contents
