Viking ONYX Series Quick Installation Manual

Hide thumbs Also See for ONYX Series:

Download this manual

ONYX Series Package Content

ONYX Series System Includes:

ONYX Series 1U

Appliance

4U/102-bay Expansion

Enclosure

AC Power Cords x 4

Mini-SAS HD x 1

RS-232 Console Cable x 1

ONYX Series Quick Installation Guide

10GbE SFP+ GBIC x 2

Slide Rail Kit x 2

ONYX Series Quick Installation Guide

Information for Installation Checklist

▪ System name:

▪ Admin password:

▪ Default username and password is admin/1234

▪ NTP server IP address:

▪ Management IP address:

▪ DNS server IP address:

Viking Enterprise Solutions has made every effort to ensure that the information contained in

this document is accurate and reliable, but assumes no responsibility for errors or omissions.

Information in this document is subject to change without notice.

This document contains copyrighted and proprietary information, which is protected by United

States copyright laws and international treaty provisions.

No part of the document may be reproduced or transmitted, in any form or by any means,

electronic or mechanical, for any purpose, without express written permission from Viking

Enterprise Solution.

Document CTC-DOC-003006

Page 1 Slide Rail Kit x 2 ©2023 Viking Enterprise Solutions™ All rights reserved. Viking Enterprise Solutions has made every effort to ensure that the information contained in this document is accurate and reliable, but assumes no responsibility for errors or omissions.
Page 2 Installing ONYX Series 1U Appliance Rail Kit Document CTC-DOC-003006 ONYX Series Quick Installation Guide...
Page 3 Enclosure Figure 1.2 Enclosure ready for removal front Carefully lift the drive carrier Release catch Accessory assembly out of the slot as demonstrated ONYX Series Quick Installation Guide Document CTC-DOC-003006...
Page 4: Installing The Enclosure Into The Rack
Installing ONYX Series Expansion Enclosure Rail Kit 8. Insert a second M5 cage nut into the square rack hole immediately below the rail, also shown in Figure 3.10. Each rail kit has two components: one left rail and one right rail. When properly installed, the rail kit’s chassis member (bolted to the sides of the enclosure) slides inside the rail kit’s cabinet member (bolted to the rack).
Page 5 5V regulators are hot-swappable and do not require the system power to be shut down during replacement. 3. Power on the ONYX Series chassis by pressing the power button on the front of the system. Discover the ONYX Series System...