Table of Contents
Advertisement
INSTALLING THE VDS41022 EXPANSION ENCLOSURE RAIL KIT
Each rail kit has two components: one left rail and one right rail. When properly
installed, the rail kit's chassis member (bolted to the sides of the enclosure) slides
inside the rail kit's cabinet member (bolted to the rack).
The rail kit includes:
▪
▪
▪
▪
▪
▪
▪
Installing the Cabinet Members into the Rack
Install the cabinet members into the standard 19-inch (48.3-centimeter) rack as
follows.
1. Adjust the length of the left cabinet member rail to match the depth of the rack.
NOTE: R (right) and L (left) are marked on the outside of the adjustable rack mounting
rails to indicate the appropriate placement.
2. Align the rail to the desired position on the front and rear left rack post.
3. Secure the left rear cabinet member rail to the rear left rack post by inserting
the stag (prongs) into the post.
4. Secure it in place using four M5 X 10 screws and four M5 conical washers.
5. Place the mounting plate onto the left front rack post, aligning the top screw
hole with the rail.
6. Verify the rail is level.
7. Insert one of the M5 cage nuts into the square rack hole immediately above the
rail as shown in Figure 3.10.
43
Viking Enterprise Solutions™ Proprietary Information
One left adjustable rack mounting rail, engraved "L".
One right adjustable rack mounting rail, engraved "R".
Two mounting plates
22 Phillips® M5 X 10 flat head screws
12 ø5.1 washers
Four M5 cage nuts
Four M5 X 13 screws
ONYX Series Harware Guide
Document CTC-DOC-003005
Advertisement
Table of Contents
