Table of Contents
Advertisement
NOTE: Use a Phillips® #2 screwdriver to loosen the thumbscrews if they are more than
finger tight.
Figure 3.4 Top cover thumbscrews
2. Use both hands to apply a gentle downward pressure on the top cover.
Slide the cover forward enough to clear the flange at the rear of the
enclosure, aligning the six guide pins (three on each side of the chassis)
with the six guide pin openings (three each on each side of the cover).
Refer to Figure 3.5 to view the guide pins and openings.
Figure 3.5 Top cover removal
3. Lift the top cover up and away from the enclosure.
Removing the Drive Carrier Assemblies
Removing the drive carrier assemblies from the enclosure can reduce the
enclosure weight by as much as 74.0 kilograms (163.2 pounds).
CAUTION: At this point in installation, it is assumed the system is being installed for
the first time and has not yet been connected to a power source. If the system has
been running, ensure there are no data transactions taking place.
Drive Mapping
38
Viking Enterprise Solutions™ Proprietary Information
If replacing a drive, follow the drive replacement instructions provided in the
section titled "Drives" on page 78 of Chapter 6.
ONYX Series Harware Guide
Flange
Guide pin
Guide pin opening
Document CTC-DOC-003005
Advertisement
Table of Contents
