Assembling The Water Pump - Yamaha R6 2009 Service Manual

3. Check:
• Water pump inlet pipe
• Water pump outlet hose
• Water pump breather hose
Cracks/damage/wear → Replace.
EAS26560

ASSEMBLING THE WATER PUMP

1. Install:
• Oil seal "1"
New
(into the water pump housing "2")
TIP
• Before installing the oil seal, apply tap water
or coolant onto its out surface.
• Install the oil seal with a socket that matches
its outside diameter.
2. Install:
• Water pump seal "1"
ECA14080
Never lubricate the water pump seal sur-
face with oil or grease.
TIP
• Install the water pump seal with the special
tools.
• Before installing the water pump seal, apply
Yamaha bond No.1215 (Three Bond
No.1215®) "2" to the water pump housing
"3".
New
6-11
Mechanical seal installer
90890-04078
Water pump seal installer
YM-33221-A
Middle driven shaft bearing
driver
90890-04058
Bearing driver 40 mm
YM-04058
Yamaha bond No. 1215
(Three Bond No.1215®)
90890-85505
A. Push down
4. Mechanical seal installer
5. Middle driven shaft bearing driver
3. Install:
• Rubber damper holder "1"
• Rubber damper "2"
TIP
Before installing the rubber damper, apply tap
water or coolant onto its outer surface.
4. Measure:
• Impeller shaft tilt
Out of specification → Repeat steps (3)
and (4).
WATER PUMP
New
New