Checking The Wheels; Checking And Lubricating The Cables; Lubricating The Levers; Lubricating The Pedals - Yamaha R6 2009 Service Manual

• Align the mark "2" with the valve installation
point.
EAS21670

CHECKING THE WHEELS

The following procedure applies to both of the
wheels.
1. Check:
• Wheel
Damage/out-of-round → Replace.
EWA13260
WARNING
Never attempt to make any repairs to the
wheel.
TIP
After a tire or wheel has been changed or
replaced, always balance the wheel.
EAS21690
CHECKING AND LUBRICATING THE
CABLES
The following procedure applies to all of the
inner and outer cables.
EWA13270
WARNING
Damaged outer cable may cause the cable
to corrode and interfere with its movement.
Replace damaged outer cable and inner
cables as soon as possible.
1. Check:
• Outer cable
Damage → Replace.
2. Check:
• Cable operation
Rough movement → Lubricate.
Recommended lubricant
Engine oil or a suitable cable
lubricant
TIP
Hold the cable end upright and pour a few
drops of lubricant into the cable sheath or use
a suitable lubricating device.
EAS21700

LUBRICATING THE LEVERS

Lubricate the pivoting point and metal-to-metal
moving parts of the levers.
Recommended lubricant
Lithium-soap-based grease
EAS21710

LUBRICATING THE PEDALS

Lubricate the pivoting point and metal-to-metal
moving parts of the pedals.
Recommended lubricant
Lithium-soap-based grease
EAS21720

LUBRICATING THE SIDESTAND

Lubricate the pivoting point and metal-to-metal
moving parts of the sidestand.
Recommended lubricant
Lithium-soap-based grease
EAS21740
LUBRICATING THE REAR SUSPENSION
Lubricate the pivoting point and metal-to-metal
moving parts of the rear suspension.
Recommended lubricant
Lithium-soap-based grease
3-35
CHASSIS