Disassembling The Water Pump; Checking The Water Pump; Assembling The Water Pump - Yamaha MBK MW125 2014 Service Manual

EAS30446

DISASSEMBLING THE WATER PUMP

1. Remove:
• Water pump seal "1"
TIP
Remove the water pump seal from the inside of
the water pump housing "2".
1
EAS30447

CHECKING THE WATER PUMP

1. Check:
• Water pump housing cover
• Water pump housing
• Impeller shaft
• Impeller shaft gear
Cracks/damage/wear → Replace.
EAS30448

ASSEMBLING THE WATER PUMP

1. Install:
• Oil seal "1" New
(into the water pump housing "2")
Installed depth "a"
0.5–1.1 mm (0.02–0.04 in)
2. Install:
• Water pump seal "1"
(into the water pump housing "2")
TIP
Install the water pump seal with the special tools
to the specified depth as shown in the illustra-
tion.
2
2
a
1
New
Installed depth of water pump
seal
0.2–0.7 mm (0.01–0.03 in)
Mechanical seal installer
90890-04145
Middle driven shaft bearing driv-
er
90890-04058
Middle drive bearing installer 40
& 50 mm
YM-04058
3
2
A. Push down
3. Mechanical seal installer
4. Middle driven shaft bearing driver
1
a. Installed depth of water pump seal
3. Lubricate:
• Water pump seal
Recommended lubricant
Lithium-soap-based grease
4. Install:
• Impeller shaft "1"
• Pin "2"
TIP
• After installing the impeller shaft, add approxi-
3
mately 0.5 cm
molybdenum disulfide oil through the hole "a"
in the water pump housing "3".
6-9
WATER PUMP
A
4
New
1
(0.017 US oz, 0.018 Imp.oz) of
a
2