Yamaha R6 2009 Service Manual page 81

1. Main switch lead
2. Left handlebar switch lead
3. Left radiator fan motor lead
4. Sidestand bracket cover
5. AC magneto lead
6. Crankcase
7. Drive sprocket cover
8. Fuel tank breather hose
9. Fuel tank drain hose
10.Drive chain guide
11.Sidestand switch lead
12.Oil level switch lead
13.Oil filter
A. 45–55 mm (1.77–2.17 in)
B. Bend the main harness as shown in the
illustration.
C. Route the plastic locking tie through the
hole of the rectifier/regulator bracket and
fasten the main harness. Face the end of
the plastic locking tie outward. Cut off the
excess end of the plastic locking tie to 1–5
mm (0.04–0.20 in).
D. Route the left radiator fan motor lead from
where engine is suspended to under the
main harness.
E. Route the starter motor lead, speed sensor
lead, sidestand switch lead and oil level
switch lead between the clamp and crank-
case shift boss. When routing, set the
starter motor lead outside. There is no
order for placing other leads.
F. The clamp on the fuel tank drain hose and
fuel tank breather hose should be below
the engine clamp.
G. 30–50 mm (1.18–1.97 in)
H. Route the fuel tank drain hose and fuel
tank breather hose through the guide of the
sidestand bracket cover. Route the side-
stand switch lead from between the guides
to inside of the hose.
I. Route the AC magneto lead between the
frame and throttle body and under the
hose.
J. After connecting the connector of the AC
magneto lead, put a cover on.
K. To the front left turn signal light.
L. Route the plastic locking tie through the
hole of the rectifier/regulator bracket and
fasten the main harness. Face the end of
the plastic locking tie outward. Cut off the
excess end of the plastic locking tie to 1–5
mm (0.04–0.20 in).
M. There is no order of setting which harness
front or back.
N. Fold back the radiator fan motor lead (main
harness side) toward back of the vehicle as
shown in the illustration and insert it into
the left coupler holder. The folded part can
be either outside or inside of the radiator
fan motor lead coupler.
O. Route the AC magneto lead under the left
radiator fan motor lead.
P. Fasten the left handle bar switch lead with
a plastic locking tie, making sure the left
handle bar switch lead is positioned as
shown in the illustration.
Q. Inside
R. Outside
S. For U49 and California, the coupler is with-
out a bullet terminal, so insertion is unnec-
essary. Connection point should be the
same as for Europe (position shown in this
illustration) (this coupler does not exist for
Canada).
T. Couplers to fasten onto the bracket are
handlebar switch lead, main switch lead
and radiator fan motor lead.
2-50
CABLE ROUTING