Table of Contents
Advertisement
14. Identify the Right Upper Body Arm (61), orient it
as shown, and hold it near the Right Upper Body
Leg (60).
See the left inset drawing. Insert the Right
Extension Wire (147) into the Right Upper
Body Leg (60) and route it out of the indicated
hole (E).
Tip: Avoid pinching the Right Extension Wire
(147). Insert the Right Upper Body Arm (61) into
the Right Upper Body Leg (60). Attach the Right
Upper Body Arm with two M8 x 45mm Bolts (96)
and two M8 Locknuts (102); make sure that the
Locknuts are in the hexagonal holes (F).
See the right inset drawing. Connect the Right
Extension Wire (147) to the Right Control Wire
(C), and insert the excess wire into the Right
Upper Body Arm (61). Next, orient the Wires
exactly as shown, and attach a zip tie (148)
around the Right Upper Body Leg (60) in the
location shown. Then, cut off the excess zip tie.
Repeat this step for the Left Upper Body
Arm (47).
15. Orient the Front Shield Cover (117) and the
Center Shield Cover (75) around the Upright (4)
as shown. Attach them to each other with two
M4 x 16mm Screws (101).
Tip: Avoid pinching the wires. Press the Front
Shield Cover (117) and the Center Shield Cover
(75) onto the Left and Right Shields (73, 74).
14
47
61
147
60
E
15
75
14
Avoid pinching
the wires
96
60
F
102
147
61
148
60
C
147
Avoid pinching
the wires
4
117
73, 74
101
Advertisement
Table of Contents
