Table of Contents
Advertisement
11. Orient the Rear Console Cover (80) as shown,
and attach it to the Upright (4) with two
M4 x 16mm Screws (101).
Then, orient the Front Console Cover (79) as
shown, and attach it to the Rear Console Cover
(80) with two M4 x 16mm Screws (101).
12. Orient the Accessory Tray (37) as shown, and
attach it to the Upright (4) with two M4 x 16mm
Screws (101).
13. Make sure that the Right Control Wire (C) is
in the location shown.
Orient a Lower Tray Cover (81) as shown, and
hold it near the Right Control Wire (C). Then,
insert the Right Control Wire into the notches
(D) in the Lower Tray Cover (see the inset
drawing).
Tip: Avoid pinching the Right Control Wire
(C). Attach the Lower Tray Cover (81) to the
right side of the Accessory Tray (37) with two
M4 x 16mm Screws (101).
Repeat this step on the other side of the
elliptical.
11
80
12
37
13
Avoid
pinching
the Right
Control
Wire (C)
13
101
79
101
101
4
4
101
D
37
81
C
101
81
D
C
Advertisement
Table of Contents
