Table of Contents
Advertisement
Service
Belt Replacement
Auger Belt
To remove and replace your snow thrower's auger belt, proceed
as follows:
1.
Allow the engine to run until it is out of fuel. Do not
attempt to pour fuel from the engine.
2.
Remove the plastic belt cover on the front of the engine by
removing the two self-tapping screws. See Figure 7-1.
Figure 7-1
NOTE: On models equipped with the LED headlight on top of
the auger housing, make sure to unplug the wire harness before
removing the belt cover as shown in Figure 7-2.
Figure 7-2
3.
If your unit is equipped with a wire belt guide, washers and
hex bolts shown in Figure 7-3 loosen and remove them.
Figure 7-3
4.
Roll the auger belt off the engine pulley. See Figure 7-4.
Figure 7-4
5.
Carefully pivot the snow thrower up and forward so that it
rests on the auger housing.
6.
7
20
Advertisement
Table of Contents
