Table of Contents
Advertisement
4.
Reattach the two carriage screws and lock nuts removed
earlier as shown in Figure 3-4.
5.
Finish securing the handle by tightening the top two lock
nuts loosened earlier. Remove and discard any remaining
rubber bands, if present. They are for packaging purposes
only.
Chute Assembly
1.
Remove the lock nuts and hex screws from chute support
bracket. Position the chute assembly over the chute base.
See Figure 3-5 .
Chute Control
1
Chute
Assembly
2
Chute Base
2.
Place chute assembly onto chute base.
8
S
3— A
ection
SSembly
Figure 3-4
Head
2
1
Chute
Support
Bracket
Figure 3-5
& S
-U
et
p
3.
Secure chute control head to chute support bracket with
the lock nuts and hex screws removed earlier. See Figure
3-6.
Figure 3-6
4.
Remove the hairpin clip from the rear of the chute control
assembly.
5.
Insert flex shaft into rear of the chute directional control
head. Secure the flex shaft to the chute control head with
the hairpin clip removed earlier. See Figure 3-7.
Figure 3-7
Advertisement
Table of Contents
