Can2 Connection - Dometic Optimus EPS Installation And User Manual

CAN1 HARNESS
TO CANTRAK
CANTRAK
Figure 5-26.
5-28
HARNESS TIE POINT X 4
HARNESSES MUST BE
STRAIN RELIEVED TO HELM
HOUSING TAB USING
CABLE TIES PROVIDED
5.6.3

CAN2 connection

The CAN2 network is used to connect the CANtrak display and a third-
party autopilot that is certified by Dometic to work with the EPS system.
The CAN2 network is optional on single-engine systems; if you are not
using an autopilot, leave the cap on the harness connector, coil the
harness, and secure it out of the way.
NOTE
The details of each autopilot's network connection will be specific to
the manufacturer, so be sure you read and understand the instructions
that come with the autopilot system.
TO CAN2
NETWORK
NODE
CM21504
HARNESS
ELECTRONIC
HELM
CAN1 HARNESS
TO ACTUATOR
HARNESS
EN