Cantrak Display; Planning; Installation - Dometic Optimus EPS Installation And User Manual

Mount vertical to hull or wall
Figure 5-16.
EN

5.5 CANtrak display

5.5.1

Planning

There are two color CANtrak displays available, as shown in table 5-4. All
displays are identical and can be used at any station.
Display
Part No.
ED1700
ED1800
Table 5-4.
5.5.2

Installation

Mount the display where it easily visible from the helm station. Consider
the following:
• Mount the display vertically, or within 60 degrees of vertical. Do not
mount it parallel to the deck unless the helm station is in an enclosed
wheelhouse where no water can accumulate on the face of the display.
• Ensure adequate ventilation around the unit.
• Ensure you can get to the rear of the unit for harness connections.
NOTE
• A CANtrak display is required at the main helm station but is optional
at secondary control stations.
• A buzzer kit (HA5493) is required at any control station without a display.
• A mounting template is in Appendix A.
<60° <60°
Mount at an angle less than 60°
For use with Notes
Twin, triple, and Comes with harness CM21504 for
quad outboard connection to both CAN1 and CAN2
vessels networks
Single outboard Comes with harness CM20030 for
vessels connection to CAN1 only
DO NOT mount parallel to boat deck
5-17