Table of Contents
Advertisement
EN
5.3.4
Harness connection to actuator
1. Remove the shipping caps from the harness connector and the
Electric Actuator.
2. Plug the connector into the actuator. The connector is keyed so that it
can only be inserted one way.
3. Tighten all four screws until they are just snug, then torque to 18–22 in-lb
(2.0–2.5 Nm).
5.4 Electronic helm
There are four helm styles available. Different helms may be used at
different stations. Mounting templates are in Appendix A.
NOTE
The EPS helm contains an electromagnet which may affect a magnetic
compass. For less than one degree of effect, the helm and compass must
be at least 24" (61cm) apart.
EPS Front Mount Helm
Part No. EH1512
EPS Classic Tilt Helm
Part No. EH1552
Figure 5-11.
EPS Sport Plus Tilt Helm
Part No. EH1532
EPS Rear Mount Helm
Part No. EH1572
5-11
Advertisement
Table of Contents
Troubleshooting
