Supero SUPERSERVER 2027TR-HTRF+ User Manual page 117

RAID Mode
The following items are displayed when RAID Mode is selected:
Port 0~5 Hot Plug
Select Enabled to enable hot-plug support for the particular port. The options
are Enabled and Disabled.
SCU Confi guration
This menu is used to confi gure SCU (Storage Controller Unit) confi guration menu
options.
SCU Devices
Select Enabled to enable support for PCH SCU (System Confi guration Utility)
devices. The options are Disabled and Enabled.
SCU RAID Option ROM
Use this feature to determine which SCU RAID device type the system will boot
from. The options are Legacy and EFI.
SCU Port 0~3 Hard Drive Status
The status of the hard drives for the above SCU ports is displayed.
PCIe/PCI/PnP Confi guration
PCI ROM Priority (Available when multiple Option ROMS are present)
Use this feature to select the Option ROM to boot the system when there are
multiple Option ROMs available in the system. The options are EFI Compatible
ROM and Legacy ROM.
PCI Latency Timer
Use this feature to set the latency Timer of each PCI device installed on a PCI bus.
Select 64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96,
128, 160, 192, 224 and 248.
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G
Address. The options are Enabled and Disabled.
7-15
Chapter 7: BIOS