Page 1
All manuals and user guides at all-guides.com Wing Span:66.9in/1700mm;Flying Weight:3000g; Wing Area:50sq.dm; Radio:4Channels 5Servos; Length:61.8in/1570mm; Engine:2C-60,4C-91; Caution:this plane is not a toy! Before use ,please carefully read this manual. ● First-time builders should seek advice from people having building experience in order to assemble the model correctly and to produce its Performance to full extent.
All manuals and user guides at all-guides.com KIT CONTENTS AILERON SERVO INSTALLATION Cut away covering film for the servo.
Page 3
All manuals and user guides at all-guides.com Glue the servo to prepared servo plywood,then put the servo into the servo hole. Pull out the servo extention from main wing. Fixup the servo by the screws, then adjust the horn and servo arm.
All manuals and user guides at all-guides.com MAIN WING INSTALLATION Find out the horns in each sides of the fuselage, then cut the film. Insert the joiner into the fuselage,and find the left and right main wing in the right position. Fixup the wings with plastic Plastic bolt...
All manuals and user guides at all-guides.com ELEVATOR & RUDDER SERVO INSTALLATION Find out and Cut off the film in the bottom of the fuselage. Cut the film along the edge of rectifier board . Glue the Rectifier board to the bottom of the fuselage. Find and cut the hole for stabilizer.
Page 6
All manuals and user guides at all-guides.com Insert the U shape wire as shown. Assemble the elevators with the U shape wire. ADJUSTMENT...
Page 7
All manuals and user guides at all-guides.com Apply AC glue to the hinges. Rudder Glue the verticle fin to the fuselage. Assemble the elevator control horn. Assemble the rudder control horn.
All manuals and user guides at all-guides.com Rudder servo TAIL WHEEL INSTALLATION Tail landing gear as shown. Amount the alumiume street to the tail fuselage. MAIN LANDING GEAR INSTALLATION Screw the wheel to the landing gear. Be assured that the screw is fixed up.
All manuals and user guides at all-guides.com Install the wheel cover, and fix it up to landing gear with TP screw. Fixup the landing gear strut to fuselage with 3 bolts. ENGINE INSTALLATION Line up the template with the firewall thrust lines and mark the location of the engine mounting holes.
All manuals and user guides at all-guides.com If use 4cycle 91 size. Install the engine mount on both sides with four 3mm screws. If use 2cycle 60 size. Use the same method to this size engine. The length from Proppler to firework is 125MM.
All manuals and user guides at all-guides.com Put the fuel tank into the fuselage, and fixup it with belt. Fuel tank detail assembly picture as shown. COWL INSTALLATION Install the cowling with 4pcs TP screws.
All manuals and user guides at all-guides.com CANOPY INSTALLATION Assemble the movable canopy. Make sure it is securitly Glue the plastic decoration on both sides of the head. CONTROL THROWS & CG POSITION...
Page 13
All manuals and user guides at all-guides.com...
Need help?
Do you have a question about the Kelly F1 60 and is the answer not in the manual?
Questions and answers