ABB ACS560 Firmware Manual page 237

No. Name/Value
Control panel (ref
saved)
Control panel (ref
copied)
Other
26.12 Torque ref2 source
26.13 Torque ref1 function
Ref1
Add (ref1 + ref2)
Sub (ref1 - ref2)
Mul (ref1 × ref2)
Min (ref1, ref2)
Max (ref1, ref2)
26.14 Torque ref1/2
selection
Torque reference 1
Torque reference 2
Description
Panel reference (03.01 Panel
saved by the control system for the location where the control
returns is used as the reference.
Reference
EXT1 -> EXT2
Panel reference (03.01 Panel
the previous control location is used as the reference when
the control location changes if the references for the two
locations are of the same type (e.g.
frequency/speed/torque/PID); otherwise, the actual signal is
used as the new reference.
Reference
EXT1 -> EXT2
Source selection (see Terms and abbreviations
Selects torque reference source 2.
For the selections, and a diagram of reference source
selection, see parameter
Selects a mathematical function between the reference
sources selected by parameters
and 26.12 Torque ref2 source. See diagram at
ref1 source.
Signal selected by 26.11 Torque ref1 source
reference 1 as such (no function applied).
The sum of the reference sources is used as torque reference
1.
The subtraction ([26.11 Torque ref1
ref2 source]) of the reference sources is used as torque
reference 1.
The multiplication of the reference sources is used as torque
reference 1.
The smaller of the reference sources is used as torque
reference 1.
The greater of the reference sources is used as torque
reference 1.
Configures the selection between torque references 1 and 2.
See diagram at 26.11 Torque ref1
0 = Torque reference 1
1 = Torque reference 2
0
1
reference, see page 168)
EXT1 reference
EXT2 reference
Active reference
Inactive reference
t
reference, see page 168) for
EXT1 reference
EXT2 reference
Active reference
Inactive reference
t
on page 162). -
26.11 Torque ref1 source.
26.11 Torque ref1 source
26.11 Torque
is used as torque
source] - [26.12 Torque
source.
Parameters 237
Def/FbEq16
18
19
Zero
Ref1
0
1
2
3
4
5
Torque
reference 1
0
1