Connect To Network And Devices; Ethernet; Wi-Fi; Turn On/Off Wi-Fi - NEC GT890 User Manual

Connect to Network and Devices

The phone supports a variety of network connections (Ethernet, Wi-Fi) and device connections, including
EHS headset (Plantronics), USB, SD card and Bluetooth device. You can connect the phone and transfer
files from/to the ITX-3370 using a USB connection, SD card or Bluetooth.

Ethernet

Ethernet connection is turned on as DHCP by default. If you would like to use Ethernet connection for
network access, please make sure the Ethernet cable is plugged in to the LAN port on the back of the
phone.
To configure Ethernet settings on the LCD:
1. Go to LCD menuSettingsNetworkEthernet settings.
2. Tap IPv4 settings.
3. Tap IPV4 Address Type to select DHCP, Static IP or PPPoE as the address type.
 For DHCP, save the setting and the ITX-3370 should be able to get IP address from the DHCP
server in the network.
 For static IP, enter IP Address, Subnet Mask, Default Gateway, DNS Server and Alternative DNS
server for the ITX-3370 to correctly connect to the network.
 For PPPoE, enter PPPoE account ID and password so phone can get an IP address from the
PPPoE server.

Wi-Fi

WI-FI is supported and built-in on the phone. The phone can be connected to network if Wi-Fi is available
within the area.

Turn On/Off Wi-Fi

1. Go to LCD menuSettingsNetworkWi-Fi.
2. Check or uncheck the option for Wi-Fi.
Or, users could open the top status bar and tap on Wi-Fi icon

Connect to Wi-Fi Networks

1. Once Wi-Fi is turned on, the phone will automatically start the scanning within the range.
2. Go to LCD menuSettingsNetworkWi-Fi.
3. A list of Wi-Fi networks will be displayed as scanning result. Tap on the SSID and enter the correct
to turn it on/off.
94