7.3
Opening the burner
Disconnect the electrical supply from the burner
by means of the main system switch.
DANGER
Close the fuel interception tap.
DANGER
Wait for the components in contact with heat
sources to cool down completely.
7.4
Closing the burner
Refit following the steps described but in reverse order; refit all
burner components as they were originally assembled.
After carrying out maintenance, cleaning or
checking operations, reassemble the hood and all
the safety and protection devices of the burner.
Maintenance
20061128
➤ Remove the tie-rod 1)(Fig. 36) of the head movement lever,
undoing the nut 2);
➤ disconnect the socket 4) of the gas servomotor;
➤ disconnect the connection to the gas pressure switch;
➤ remove the screws 3);
➤ partially open the burner;
➤ disconnect the electrodes and the ionisation probe.
➤ At this point, it is possible to open the burner on the hinge.
33
GB
Fig. 36
20087244