Yamaha XMAX Connected 2023 Owner's Manual page 110

Periodic maintenance and adjustment
switch off, then disconnect the
negative lead before discon-
necting the positive lead.
2. If the battery will be stored for
more than two months, check it at
least once a month and fully
charge it if necessary.
3. Fully charge the battery before in-
stallation. NOTICE: When install-
ing the battery, be sure to turn
the main switch off, then con-
nect the positive lead before
connecting the negative lead.
[ECA16842]
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
9 NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
Replacing the fuses
The main fuse and the fuse boxes,
[ECA16304]
which contain the fuses for the individ-
ual circuits, are located under panel A.
(See page 9-8.)
TIP
To access the main fuse, remove the
starter relay cover as shown.
1
ECA16531
4
1. Fuse box
2. Main fuse
3. Spare main fuse
4. Starter relay cover
9-29
EAUN4021
5
4
3
2
1
1. ABS motor fuse
2. ABS solenoid fuse
3. Signaling system fuse 2
4. Terminal fuse
2
5. Ignition fuse 2
6. Signaling system fuse 1
7. ABS control unit fuse
3
8. Fuse puller
9. Spare fuse
10.Ignition fuse 1
11.Radiator fan motor fuse
12.Backup fuse
If a fuse is blown, replace it as follows.
1. Turn the main switch off and turn
off the electrical circuit in ques-
tion.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
6 7 8
12 11 10 9