5
Installation
5.1
Notes on safety for the installation
After carefully cleaning all around the area where the burner will
be installed, and arranging the correct lighting of the environ-
ment, proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
5.2
Handling
The transport weight is given in chapter page 7.
Observe the permissible ambient temperatures for storage and
transport: -20 ..... + 70°C, with max. relative air humidity 80%.
After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material.
Before proceeding with the installation operations,
carefully clean all around the area where the
burner will be installed.
CAUTION
5.3
Preliminary checks
Checking the consignment
After removing all the packaging, check the integ-
rity of the contents. In the event of doubt, do not
use the burner; contact the supplier.
CAUTION
The packaging elements (wooden cage or card-
board box, nails, clips, plastic bags, etc.) must not
be abandoned as they are potential sources of
danger and pollution; they should be collected and
disposed of in the appropriate places.
Installation
The installation of the burner must be carried out
by qualified personnel, as indicated in this manual
and in compliance with the standards and regula-
tions of the laws in force.
WARNING
The operator must use the required equipment
during installation.
Checking the characteristics of the burner
S8585
Check the identification label of the burner, showing:
the model A)(Fig. 4) and type of burner B);
the year of manufacture, in cryptographic form C);
the serial number D);
the electrical input power E);
the electrical power consumption F);
the types of fuel used and the relative supply pressures G);
the data of the burner's minimum and maximum output pos-
sibilities H)(see Firing rate)
The output of the burner must be within the
boiler's firing rate;
WARNING
A burner label that has been tampered with, re-
moved or is missing, along with anything else that
prevents the definite identification of the burner
makes any installation or maintenance work diffi-
WARNING
cult.
9
GB
Fig. 4
20163551