Installing The Wall Control - Hinkley 48" CHET Manual

INSTALLING THE WALL CONTROL

REMEMBER to turn off the power before you begin.
NOTE: 1. Control must be installed within 30 feet of fan.
2. Secures to any surface or application: flat wall, single
gang box, multi gang box.
Option 1. Flat Surface Installation
Select a desired location. Use the wall plate to mark the
1
location of the mounting holes. Plastic wall anchors or
mounting screws are needed for this application. (Fig. 1)
Seat the cradle B into the wall plate. Secure the wall plate to
2
the wall using the provided hardware.
Snap the face plate cover onto the wall bracket.
3
Remote transmitter will be held in place with built in magnets.
4
Wall plate
Plastic
anchor
Wall
Figure 1
HIRO Control System
12 hinkley.com
Cradle B
Face plate
Transmitter
Option 2. For Single Gang Box
Remove the existing wall plate and the old switch from the wall
1
outlet box.
Seat the cradle A into the wall plate. (Fig. 2)
2
Connect the black lead wires from the switch in the cradle A to
3
the black wires in the switch box. Hot input wire to one of the
cradle A switch leads. Power lead to the fan is connected to
the remaining switch lead.
Connect the wall plate / cradle A assembly to the wall outlet
4
box using the supplied hardware.
5 Snap the face plate cover onto the wall bracket.
6 Remote transmitter will be held in place with built in magnets.
Outlet box
Wall plate
Figure 2
Cradle A
Face plate
Transmitter